Now it’s time to upload the sketch (program) to the Arduino and tell it what to do. Step 6 – Connect the Arduino Uno to your computer via USB cable Upload The Blink Sketch Step 5 – Bend both legs of a 220 Ohm resistor and place one leg in the GND rail around row 4 and other leg in I4 Step 4 – Place the SHORT leg of the LED into H4 Step 3 – Place the LONG leg of the LED into H7 Step 2 – Insert red jumper wire into pin 13 on the Arduino and then the other end into F7 on the breadboard Step 1 – Insert black jumper wire into the GND (Ground) pin on the Arduino and then in the GND rail of the breadboard row 15 If we mention H19 for example, that refers to column H, row 19 on the breadboard. In the written description, we will use a letter/number combo that refers to the location of the component. You can build your Arduino circuit by looking at the breadboard image above or by using the written description below. Need the parts? Get the Arduino Starter Kit w/ Project Ebook Connect The Parts If you need a refresher on the parts of the Arduino or how a breadboard works, check out our previous tutorial called Arduino For Beginners. ![]() In this example, we are going to make your Arduino board blink an LED. It’s finally time to do your first Arduino project. To select the port, go to Tools then Port then select the port that says Arduino. Next, you have to tell the Arduino which port you are using on your computer. Once the board is connected, you will need to go to Tools then Board then finally select Arduino Uno. Plug one end of the USB cable to the Arduino Uno and then the other end of the USB to your computer’s USB port.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |